
Electrician in Neutral Bay
Unit board upgrades and kitchen circuits for Neutral Bay flats, from interwar blocks to post-war walk-ups.
Your Neutral Bay Electrician
Our licensed electricians cover Neutral Bay from Terrey Hills, and most jobs there are inside apartments. A frequent one is a unit board too small for an induction cooktop, which needs its own heavier circuit. Ceiling fans in flats without air conditioning are another, as are full rewires when a unit is gutted for renovation. Phone 0478 045 154. End Point Electrical, NSW licence 397311C.
Nearby suburbs we cover
- Cremorne
- Cammeray
- North Sydney
- Kirribilli

- Based in
- Terrey Hills NSW 2084
- Hours
- Mon to Fri 7am to 5pm, Sat 7am to 12pm
- NSW licence
- 397311C
- Phone
- 0478 045 154
Neutral Bay 2089
Neutral Bay: interwar flats and walk-ups close to the harbour
Apartments make up most of the housing in Neutral Bay. A large share are older blocks, from interwar flats with their brick detailing to the plainer walk-ups of the 1950s and 1960s, along with newer buildings near the shops. Houses are fewer and mostly older, on the quieter streets towards the water.
In the older flats, the unit board is often small, with rewireable fuses or one safety switch, and the supply into the unit is modest. That matters when owners renovate a kitchen and want an induction cooktop or an electric oven, since each needs a dedicated circuit. Some units cannot take that load without a new board or a check of the supply cable, which can be common property. Many flats also have no air conditioning, so ceiling fans are a regular request.
Typical jobs
Typical Jobs in Neutral Bay
What the work usually involves, how long it takes and what you are left with when we pack up.
Switchboard upgrade
Small fuse-era unit boards in Neutral Bay flats, upgraded so a new induction cooktop or oven has its own protected circuit.
The board we usually replace is an older one with ceramic fuses, or with only one or two safety switches (RCDs). It comes out and a new board goes in with circuit breakers and RCD protection on the circuits. We size it with spare room for later additions like air conditioning or an EV charger. Expect the power to be off for most of the job.
- Usual time on site
- 4 to 6 hours
- You end up with
- A labelled switchboard with tested RCD protection and a Certificate of Compliance for Electrical Work (CCEW)
Fan install
Ceiling fans in Neutral Bay bedrooms and living rooms, usually fitted to an existing light point in units without air conditioning.
Typical fan jobs are a ceiling fan going in where an old light was, or a tired bathroom exhaust fan swapped for a stronger one ducted to the outside. Heat lamp and fan combos suit bathrooms that stay cold in winter. If you want a new wall control or a separate switch for the fan, we run that cable on the same visit.
- Usual time on site
- 1 to 2 hours
- You end up with
- A balanced, quiet fan on its own control, with a CCEW for the installation
Build or renovation wiring
Full rewires when a Neutral Bay unit is stripped back for renovation, with new power points placed for the new layout.
We start from your plans and draw the lighting and power layout room by room. Cable goes in at rough-in while the frame is open, with each run photographed, and fit-off happens once the surfaces are finished. We work to the builder’s program and size the switchboard for what you plan to add later, so a late change rarely means opening walls.
- You end up with
- Every circuit and safety switch tested, with a CCEW at handover
Bigger Projects We Have Wired
Two builds that show how we plan and run a job from first drawings to handover.
What Our Clients Say About End Point Electrical
5.0 from 14 Google reviews- Rated 5 out of 5
“I can highly recommend End Point Electrical. They have provided exemplary service to me, undertaking electrical and network wiring work at both my previous townhouse and my current apartment. They are so good that I have signed them up as the preferred supplier to our building, of which I am the strata committee chair.”
Graham Lewis
- Rated 5 out of 5
“Andrew and Jake have been amazing and professional to work with. They've fixed power points and replaced light fittings at my place. I've since recommended them to both my parents and grandparents where a fuse box upgrade has been completed for my fathers place and an oven install along with lighting and ceiling fans for my grandmother. Both have had nothing but positive things to say. Would highly recommend!”
Reece Tailby
- Rated 5 out of 5
“I recently completed a major renovation on my home where we essentially rebuilt it stage by stage, eventually tripling the size of the house. Endpoint Electrical wired the entire project and were fantastic to work with from start to finish. Our build was a little unconventional compared to a standard new build, as we were living in the house the whole time. This meant the electrical work had to constantly adapt — thinking about both the present and the future, with some areas not even built yet while others were scheduled to be removed later on. Despite the challenges, the team handled everything professionally and thoughtfully. They are exceptional at what they do, very easy to communicate with, can think out of the box and all round a top blokes. I use them when ever I can and recommend to all.”
Benjamin Williams
- Rated 5 out of 5
“Had fans, power points and tv speakers installed. Guys did an amazing job, quick, clean and very polite. Highly recommended”
Nathanael Merchant
- Rated 5 out of 5
“We have used Andy and Jake from End Point Electrical for many years for electrical works at our house and always found them fantastic. Would highly recommend them!”
Andy Crow
- Rated 5 out of 5
“Highly recommend End Point Electrical - Jake, Andrew and the staff are all fantastic to work with and do a great job. We have had the team install a new electrical box, kitchen renovations, ceiling fans and much more. Each job has been done professionally and seamlessly. Thanks!!”
Naomi Cohen
- Rated 5 out of 5
“Andy, Jake and their team were fantastic. Great communication, showed up when they said they would and with all materials there. They adapted smoothly to my atypical problems and their attention to detail was outstanding. Their work is so neat and tidy I asked them to back to tidy up a previous electrician's messy cabling. I've recommended End Point to multiple friends already and will keep coming back.”
Adam Farrow-Palmer
- Rated 5 out of 5
“Andy and his team of electricians are true professionals. All electrical jobs are well considered and undertaken with care to provide the best possible outcome. Whether the job is large or small, Andy will continue to investigate the issue to achieve the desired result and he provides exceptional service which is rare to find these days. I have no hesitation in recommending End Point Electrical for all your electrical needs.”
Melanie Bloom
- Rated 5 out of 5
“Couldn’t recommend them higher! I was doing renovations on my house and I got the boys from end point electrical to come in. From the get go it was so easy they looked at my property gave me a quote and the price was very reasonable. They got it done with no issues and their customer service was amazing! They updated me when I needed to be. The quality of the work was amazing! They were great blokes to deal with. If you’re looking for the best couldn’t recommend them any higher! Would also have a beer with them!”
Tristan Black
- Rated 5 out of 5
“Excellent communication and quality of work. Very professional, would highly recommend.”
Dexywilson
- Rated 5 out of 5
“Did an amazing job and cleaned up after they finished. Pricing was great, and will definitely use them again.”
Ryan Hutton
- Rated 5 out of 5
“Andrew & Jake were exceptional when it came to the electrical package for my project! There assistance within pre construction and helping achieve the electrical budget was outstanding, and there recommendations for light fittings and value management options is what made the build come to life for me and my family! Very glad my builder recommended/uses them - and I strongly suggest you give these fella a call!”
Ben Rasmussen
- Rated 5 out of 5
“Andrew and Jake and all the boys are always super helpful clean up after themselves Respectful to clients turn up when they say they will. You will have a great result at a fair price”
Mat Chakley BRACE
- Rated 5 out of 5
“I recently used End Point Electrical for a renovation. Their team was terrific. Professional, on time on budget, and solution orientated. Highly recommend them.”
Harald Svensen
Neutral Bay Electrician FAQs
Can my Neutral Bay unit run an induction cooktop?
Many can, but it depends on the unit board and the supply into the unit. An induction cooktop needs its own circuit of a suitable rating. In older flats the board may be too small, or the supply cable may need checking, and that cable is often common property. We look at both before you buy, so you know what the job involves.
Do I need strata approval to rewire my Neutral Bay apartment?
Work inside your unit, from your own board onwards, is usually yours to arrange, though many by-laws ask you to notify the strata manager about renovations. Anything touching the meters or the main supply normally needs approval, as does cutting into common walls. Check your by-laws first, and we can explain the scope of work to the strata manager.
Can a ceiling fan go on a concrete ceiling in a Neutral Bay flat?
Yes. On a concrete slab we fix the fan with anchors rated for its weight, at the existing light point where possible. If there is no light point in the right spot, the cable can run in a slim surface conduit. We check the ceiling height too, so the blades sit at a safe distance above the floor.

Book an Electrician in Neutral Bay
Call 0478 045 154, or send through the job and your address in Neutral Bay and we will come back to you with a quote.


