
Electrician in Beecroft
Switchboard and heating circuits for Beecroft households replacing gas with electric under the tall trees.
Your Beecroft Electrician
In Beecroft, a typical request is help moving a house off gas. End Point Electrical checks the supply, sizes the switchboard for reverse cycle heating and an induction cooktop, then runs the new circuits. Older homes in the heritage area may need some rewiring first, which is easier to do at the same time. We come over from Terrey Hills. Call 0478 045 154. NSW contractor licence 397311C.
Nearby suburbs we cover
- Cheltenham
- Pennant Hills
- Epping

- Based in
- Terrey Hills NSW 2084
- Hours
- Mon to Fri 7am to 5pm, Sat 7am to 12pm
- NSW licence
- 397311C
- Phone
- 0478 045 154
Beecroft 2119
Beecroft: big blocks, tall gums and older homes going electric
Beecroft is a suburb of detached houses on large blocks under a heavy tree canopy, and a good share of it falls within the Beecroft-Cheltenham heritage conservation area. The housing runs from Federation and interwar homes through to post-war brick and mid-century designs. Many were built with gas heating and gas cooking, and the switchboard was sized for a house that used far less electricity than it does now.
When owners swap gas heaters for reverse cycle air conditioning and the gas cooktop for induction, the electrical load climbs. We check the supply and the board first, since an older board may have no spare slots and limited RCD cover. Some houses need a new board, and a few need a supply upgrade arranged through the network operator. Older cable found along the way is replaced while we are in the roof.
Typical jobs
Typical Jobs in Beecroft
What the work usually involves, how long it takes and what you are left with when we pack up.
Air conditioning circuit
Reverse cycle systems replacing gas heaters in Beecroft homes, each on a circuit sized for it.
Most heating and cooling work starts at the switchboard. A split system or ducted unit needs its own circuit and an isolator at the outdoor unit, sized for what the system draws, and older boards often need upgrading first. We wire for brands such as Daikin and Mitsubishi Electric. Electric underfloor heating in bathrooms is another regular job.
- You end up with
- A dedicated, tested circuit for the system and a CCEW
Switchboard upgrade
Boards in older Beecroft houses replaced with spare slots for heating, cooling and an induction cooktop.
The board we usually replace is an older one with ceramic fuses, or with only one or two safety switches (RCDs). It comes out and a new board goes in with circuit breakers and RCD protection on the circuits. We size it with spare room for later additions like air conditioning or an EV charger. Expect the power to be off for most of the job.
- Usual time on site
- 4 to 6 hours
- You end up with
- A labelled switchboard with tested RCD protection and a Certificate of Compliance for Electrical Work (CCEW)
Build or renovation wiring
Rewiring in Beecroft heritage homes, kept inside the walls and roof space so the street view is unchanged.
We start from your plans and draw the lighting and power layout room by room. Cable goes in at rough-in while the frame is open, with each run photographed, and fit-off happens once the surfaces are finished. We work to the builder’s program and size the switchboard for what you plan to add later, so a late change rarely means opening walls.
- You end up with
- Every circuit and safety switch tested, with a CCEW at handover
Bigger Projects We Have Wired
Two builds that show how we plan and run a job from first drawings to handover.
What Our Clients Say About End Point Electrical
5.0 from 14 Google reviews- Rated 5 out of 5
“Andy and his team of electricians are true professionals. All electrical jobs are well considered and undertaken with care to provide the best possible outcome. Whether the job is large or small, Andy will continue to investigate the issue to achieve the desired result and he provides exceptional service which is rare to find these days. I have no hesitation in recommending End Point Electrical for all your electrical needs.”
Melanie Bloom
- Rated 5 out of 5
“Andrew and Jake have been amazing and professional to work with. They've fixed power points and replaced light fittings at my place. I've since recommended them to both my parents and grandparents where a fuse box upgrade has been completed for my fathers place and an oven install along with lighting and ceiling fans for my grandmother. Both have had nothing but positive things to say. Would highly recommend!”
Reece Tailby
- Rated 5 out of 5
“Couldn’t recommend them higher! I was doing renovations on my house and I got the boys from end point electrical to come in. From the get go it was so easy they looked at my property gave me a quote and the price was very reasonable. They got it done with no issues and their customer service was amazing! They updated me when I needed to be. The quality of the work was amazing! They were great blokes to deal with. If you’re looking for the best couldn’t recommend them any higher! Would also have a beer with them!”
Tristan Black
- Rated 5 out of 5
“Excellent communication and quality of work. Very professional, would highly recommend.”
Dexywilson
- Rated 5 out of 5
“I recently completed a major renovation on my home where we essentially rebuilt it stage by stage, eventually tripling the size of the house. Endpoint Electrical wired the entire project and were fantastic to work with from start to finish. Our build was a little unconventional compared to a standard new build, as we were living in the house the whole time. This meant the electrical work had to constantly adapt — thinking about both the present and the future, with some areas not even built yet while others were scheduled to be removed later on. Despite the challenges, the team handled everything professionally and thoughtfully. They are exceptional at what they do, very easy to communicate with, can think out of the box and all round a top blokes. I use them when ever I can and recommend to all.”
Benjamin Williams
- Rated 5 out of 5
“Did an amazing job and cleaned up after they finished. Pricing was great, and will definitely use them again.”
Ryan Hutton
- Rated 5 out of 5
“Andrew & Jake were exceptional when it came to the electrical package for my project! There assistance within pre construction and helping achieve the electrical budget was outstanding, and there recommendations for light fittings and value management options is what made the build come to life for me and my family! Very glad my builder recommended/uses them - and I strongly suggest you give these fella a call!”
Ben Rasmussen
- Rated 5 out of 5
“Andrew and Jake and all the boys are always super helpful clean up after themselves Respectful to clients turn up when they say they will. You will have a great result at a fair price”
Mat Chakley BRACE
- Rated 5 out of 5
“Had fans, power points and tv speakers installed. Guys did an amazing job, quick, clean and very polite. Highly recommended”
Nathanael Merchant
- Rated 5 out of 5
“We have used Andy and Jake from End Point Electrical for many years for electrical works at our house and always found them fantastic. Would highly recommend them!”
Andy Crow
- Rated 5 out of 5
“I can highly recommend End Point Electrical. They have provided exemplary service to me, undertaking electrical and network wiring work at both my previous townhouse and my current apartment. They are so good that I have signed them up as the preferred supplier to our building, of which I am the strata committee chair.”
Graham Lewis
- Rated 5 out of 5
“I recently used End Point Electrical for a renovation. Their team was terrific. Professional, on time on budget, and solution orientated. Highly recommend them.”
Harald Svensen
- Rated 5 out of 5
“Highly recommend End Point Electrical - Jake, Andrew and the staff are all fantastic to work with and do a great job. We have had the team install a new electrical box, kitchen renovations, ceiling fans and much more. Each job has been done professionally and seamlessly. Thanks!!”
Naomi Cohen
- Rated 5 out of 5
“Andy, Jake and their team were fantastic. Great communication, showed up when they said they would and with all materials there. They adapted smoothly to my atypical problems and their attention to detail was outstanding. Their work is so neat and tidy I asked them to back to tidy up a previous electrician's messy cabling. I've recommended End Point to multiple friends already and will keep coming back.”
Adam Farrow-Palmer
Beecroft Electrician FAQs
We want to get off gas in our Beecroft home. Where do we start?
Start with the switchboard and the supply. We list what you plan to add, such as reverse cycle heating and an induction cooktop, then check whether the board and the incoming supply can carry it. That tells you if the board needs replacing first. Working in that order avoids adding circuits to a board that will soon come out.
Where should the outdoor air conditioning units go on a Beecroft heritage house?
Placement is mostly a planning question rather than an electrical one. In a heritage area it is sensible to keep outdoor units out of view from the street, and the council may have a view, so check before you commit. Once the spot is settled, we run a dedicated circuit and fit an isolator beside each unit.
Is the old wiring in our Beecroft house safe to keep?
It depends on what is there. Houses from the interwar years can still have rubber-insulated cable in the roof, which turns brittle with age and should be replaced. Post-war houses usually have PVC cable that is often fine. We test the insulation and look at the cable itself, then tell you which circuits are worth redoing.

Book an Electrician in Beecroft
Call 0478 045 154, or send through the job and your address in Beecroft and we will come back to you with a quote.


