
Electrician in Narraweena
Wiring for the downstairs flats and granny flats that many Narraweena owners add on their sloping blocks.
Your Narraweena Electrician
Narraweena is hilly, and plenty of homes have space under the house or down the back that owners turn into a flat. End Point Electrical wires those conversions from our base in Terrey Hills, usually with a sub-board for the new space. Circuits for a split system in the new rooms often follow. Get in touch on 0478 045 154. Our NSW contractor licence is 397311C.
Nearby suburbs we cover
- Dee Why
- Beacon Hill
- Cromer
- Collaroy Plateau

- Based in
- Terrey Hills NSW 2084
- Hours
- Mon to Fri 7am to 5pm, Sat 7am to 12pm
- NSW licence
- 397311C
- Phone
- 0478 045 154
Narraweena 2099
Narraweena: post-war homes on hillside blocks
Narraweena climbs the hill behind Dee Why, and most of it is post-war brick and fibro houses on sloping blocks. The slope often leaves a high-set floor with a garage or storage space underneath, and many owners have converted that space into a rumpus room or a self-contained flat. Others build a granny flat down the back. Either way the new space needs its own lighting and power, and usually a sub-board fed from the main switchboard.
A separate flat may also need interconnected smoke alarms or its own meter, depending on how it is approved, so we like to see the council or certifier paperwork early. The original boards in these houses were sized for a smaller household, and adding a kitchenette and an air conditioner downstairs can push them past their limit. Checking capacity before the plasterer arrives saves rework.
Typical jobs
Typical Jobs in Narraweena
What the work usually involves, how long it takes and what you are left with when we pack up.
Build or renovation wiring
Lighting and power for under-house conversions and granny flats on sloping Narraweena blocks.
We start from your plans and draw the lighting and power layout room by room. Cable goes in at rough-in while the frame is open, with each run photographed, and fit-off happens once the surfaces are finished. We work to the builder’s program and size the switchboard for what you plan to add later, so a late change rarely means opening walls.
- You end up with
- Every circuit and safety switch tested, with a CCEW at handover
Switchboard upgrade
Sub-boards for new Narraweena flats, with the main board checked for capacity before work starts.
The board we usually replace is an older one with ceramic fuses, or with only one or two safety switches (RCDs). It comes out and a new board goes in with circuit breakers and RCD protection on the circuits. We size it with spare room for later additions like air conditioning or an EV charger. Expect the power to be off for most of the job.
- Usual time on site
- 4 to 6 hours
- You end up with
- A labelled switchboard with tested RCD protection and a Certificate of Compliance for Electrical Work (CCEW)
Air conditioning circuit
Split system circuits for Narraweena rumpus rooms and downstairs flats.
Most heating and cooling work starts at the switchboard. A split system or ducted unit needs its own circuit and an isolator at the outdoor unit, sized for what the system draws, and older boards often need upgrading first. We wire for brands such as Daikin and Mitsubishi Electric. Electric underfloor heating in bathrooms is another regular job.
- You end up with
- A dedicated, tested circuit for the system and a CCEW
Bigger Projects We Have Wired
Two builds that show how we plan and run a job from first drawings to handover.
What Our Clients Say About End Point Electrical
5.0 from 14 Google reviews- Rated 5 out of 5
“Andy and his team of electricians are true professionals. All electrical jobs are well considered and undertaken with care to provide the best possible outcome. Whether the job is large or small, Andy will continue to investigate the issue to achieve the desired result and he provides exceptional service which is rare to find these days. I have no hesitation in recommending End Point Electrical for all your electrical needs.”
Melanie Bloom
- Rated 5 out of 5
“Andrew and Jake have been amazing and professional to work with. They've fixed power points and replaced light fittings at my place. I've since recommended them to both my parents and grandparents where a fuse box upgrade has been completed for my fathers place and an oven install along with lighting and ceiling fans for my grandmother. Both have had nothing but positive things to say. Would highly recommend!”
Reece Tailby
- Rated 5 out of 5
“Couldn’t recommend them higher! I was doing renovations on my house and I got the boys from end point electrical to come in. From the get go it was so easy they looked at my property gave me a quote and the price was very reasonable. They got it done with no issues and their customer service was amazing! They updated me when I needed to be. The quality of the work was amazing! They were great blokes to deal with. If you’re looking for the best couldn’t recommend them any higher! Would also have a beer with them!”
Tristan Black
- Rated 5 out of 5
“Excellent communication and quality of work. Very professional, would highly recommend.”
Dexywilson
- Rated 5 out of 5
“I recently completed a major renovation on my home where we essentially rebuilt it stage by stage, eventually tripling the size of the house. Endpoint Electrical wired the entire project and were fantastic to work with from start to finish. Our build was a little unconventional compared to a standard new build, as we were living in the house the whole time. This meant the electrical work had to constantly adapt — thinking about both the present and the future, with some areas not even built yet while others were scheduled to be removed later on. Despite the challenges, the team handled everything professionally and thoughtfully. They are exceptional at what they do, very easy to communicate with, can think out of the box and all round a top blokes. I use them when ever I can and recommend to all.”
Benjamin Williams
- Rated 5 out of 5
“Did an amazing job and cleaned up after they finished. Pricing was great, and will definitely use them again.”
Ryan Hutton
- Rated 5 out of 5
“Andrew & Jake were exceptional when it came to the electrical package for my project! There assistance within pre construction and helping achieve the electrical budget was outstanding, and there recommendations for light fittings and value management options is what made the build come to life for me and my family! Very glad my builder recommended/uses them - and I strongly suggest you give these fella a call!”
Ben Rasmussen
- Rated 5 out of 5
“Andrew and Jake and all the boys are always super helpful clean up after themselves Respectful to clients turn up when they say they will. You will have a great result at a fair price”
Mat Chakley BRACE
- Rated 5 out of 5
“Had fans, power points and tv speakers installed. Guys did an amazing job, quick, clean and very polite. Highly recommended”
Nathanael Merchant
- Rated 5 out of 5
“We have used Andy and Jake from End Point Electrical for many years for electrical works at our house and always found them fantastic. Would highly recommend them!”
Andy Crow
- Rated 5 out of 5
“I can highly recommend End Point Electrical. They have provided exemplary service to me, undertaking electrical and network wiring work at both my previous townhouse and my current apartment. They are so good that I have signed them up as the preferred supplier to our building, of which I am the strata committee chair.”
Graham Lewis
- Rated 5 out of 5
“I recently used End Point Electrical for a renovation. Their team was terrific. Professional, on time on budget, and solution orientated. Highly recommend them.”
Harald Svensen
- Rated 5 out of 5
“Highly recommend End Point Electrical - Jake, Andrew and the staff are all fantastic to work with and do a great job. We have had the team install a new electrical box, kitchen renovations, ceiling fans and much more. Each job has been done professionally and seamlessly. Thanks!!”
Naomi Cohen
- Rated 5 out of 5
“Andy, Jake and their team were fantastic. Great communication, showed up when they said they would and with all materials there. They adapted smoothly to my atypical problems and their attention to detail was outstanding. Their work is so neat and tidy I asked them to back to tidy up a previous electrician's messy cabling. I've recommended End Point to multiple friends already and will keep coming back.”
Adam Farrow-Palmer
Narraweena Electrician FAQs
Does a granny flat in Narraweena need its own switchboard?
Usually it has a sub-board fed from the main switchboard of the house, with its own RCDs and main switch. Whether it also needs a separate meter depends on how the flat is approved and whether you want to bill it separately. We size the submain to the flat's load and check that the main board can supply it.
We are converting the space under our Narraweena house. What electrical work is involved?
Typically new lighting and power circuits plus smoke alarms. A bathroom adds an exhaust fan, and many owners add a split system. Under-house spaces can be damp, so cable routes and fittings need to suit that. We work from your plans, rough in while the frame is open, then fit off once the walls are lined.
Will my old Narraweena switchboard cope with a downstairs flat?
Often not without changes. Boards in post-war houses were sized for far less load than a modern household uses, and a flat adds cooking and cooling on top. We check the supply to the house and the spare space on the board. If either falls short, a board upgrade or a supply upgrade comes before the flat is connected.

Book an Electrician in Narraweena
Call 0478 045 154, or send through the job and your address in Narraweena and we will come back to you with a quote.


